YY2000-C has dynamic simulation diagram, digital display of temperature and humidity inside the cabinet (LCD or digital display) and programmable control, live display and shutdown, intelligent voice error prevention function, and can also be configured with RS485 digital communication, human body induction function, It has a high-voltage live self-test function and a nuclear phase power test port, and corresponding control transfer switches (including energy storage switches, remote/local transfer switches, and opening and closing transfer switches) can be installed on the device according to the user's control requirements. After the temperature and humidity control is digitized, users can freely set the upper and lower limits of heating/dehumidification output and the upper and lower limits of overheated exhaust and other parameters as needed, making temperature and humidity control more effective and targeted.
1. The dynamic root indication input part (sub 21#~27#) must be connected to a passive dry contact. The connection of live lines will damage the device.
2. The temperature and humidity control parameters have been set according to the general control requirements when leaving the factory. If there are no special requirements, there is no need to change them.
3. When it is necessary to conduct a high-voltage test that is more than 2 times the nominal voltage, please first remove the high-voltage live display wiring braid on the device, and connect the high-voltage live display terminals to the device.
When ordering, users need to fax or email the primary system diagram and transfer switch contact diagram to our company, indicating the specific model and quantity of the ordered product, and specifying one or more of the following functions:
1. Dynamic simulation diagram " If there is a circuit breaker, whether it should be able to indicate:
2. Temperature control in the cabinet "One-way or two-way temperature sensor control":
3. High-voltage live display and live shutdown:
4. RS485 communication interface. Our company will make a product plan based on the primary system diagram and the specific requirements of the user. After the user confirms the plan, we will start customizing the product.
